This commit introduces the concept of an accumulator register to
LibJS's bytecode interpreter. The accumulator register is always
register 0, and most simple instructions use it for reading and
writing.
Not only does this slim down the AST, but it also simplifies a lot of
the code. For example, the generate_bytecode methods no longer need
to return an Optional<Register>, as any opcode which has a "return"
value will always put it into the accumulator.
This also renames the old Op::Load to Op::LoadImmediate, and uses
Op::Load to load from a register into the accumulator. There is
also an Op::Store to put the value in the accumulator into another
register.
After compiling bytecode, we should mark the memory read-only.
This currently does not work because it breaks instruction destruction.
I'm adding this anyway with a FIXME so we don't forget about it. :^)
This patch changes the LibJS bytecode to be a stream of instructions
packed one-after-the-other in contiguous memory, instead of a vector
of OwnPtr<Instruction>. This should be a lot more cache-friendly. :^)
Instructions are also devirtualized and instead have a type field
using a new Instruction::Type enum.
To iterate over a bytecode stream, one must now use
Bytecode::InstructionStreamIterator.
Unlike the convoluted unwind-until-scope-type mechanism in the AST
interpreter, "continue" maps to a simple Bytecode::Op::Jump here. :^)
We know where to jump based on a stack of "continuable scopes" that
we now maintain on the Bytecode::Generator as we go.
Note that this only supports bare "continue", not continue-with-label.
This introduces two new instructions: Jump and JumpIfFalse.
Jumps are made to a Bytecode::Label, which is a simple object that
represents a location in the bytecode stream.
Note that you may not always know the target of a jump when adding the
jump instruction itself, but we can just update the instruction later
on during codegen once we know where the jump target is.
The Bytecode::Interpreter now implements jumping via a jump slot that
gets checked after each instruction to see if a jump is pending.
If not, we just increment the PC as usual.
This patch begins the work of implementing JavaScript execution in a
bytecode VM instead of an AST tree-walk interpreter.
It's probably quite naive, but we have to start somewhere.
The basic idea is that you call Bytecode::Generator::generate() on an
AST node and it hands you back a Bytecode::Block filled with
instructions that can then be interpreted by a Bytecode::Interpreter.
This first version only implements two instructions: Load and Add. :^)
Each bytecode block has infinity registers, and the interpreter resizes
its register file to fit the block being executed.
Two new `js` options are added in this patch as well:
`-d` will dump the generated bytecode
`-b` will execute the generated bytecode
Note that unless `-d` and/or `-b` are specified, none of the bytecode
related stuff in LibJS runs at all. This is implemented in parallel
with the existing AST interpreter. :^)
